maandag 5 januari 2009

rudder(case) part 4 + trailer

Happy new year everyone. I made a bit of progress last few days.

Laminating the ruddercase with carbon was not difficult and a nice job to do. Below is the case with the stub shaped in foam.The tiller stub was the last piece I had to 'wrap' with cloth, luckily. I still haven't got the hang of it - and now I probably never will unless I'm going to build another fiberglass boat - and had a really hard time to get this piece right. I used vacuumbagging and also plastic and packing-tape in an attempt to keep the cloth in place, but it was not a big succes. Had to re-laminate the front of the stub.
Here's the end-result. Good enough for me. I have to glue&laminate the stub to the ruddercase and then I can finish & paint the rudder and the ruddercase.

I also bought an american-style trailer. It's very wide - only a few cm less wide than the maximum-width allowed over here. I'll probably have to add some extra tubes to be able to mount all the supports/rollers/etc.



2 opmerkingen:

Kees Zevenbergen zei

Hé, dat hekje ken ik!. Wat een geweldig onderneming is dit zeg! 't Ziet er allemaal prachtig uit. Stoffig, dat wel! Waar gebeurt dit bouwen allemaal? Ik kom graag eens kijken als ik in de buurt ben. Hartelijke groet, en keep up the good work.
Kees

Menno zei

Ha Kees,

Het bouwen gebeurde eerst bij mij op zolder (tot groot verdriet van Jacomien) en momenteel (hoofdromp) op een zolder van een slooppand.
Zie de foto's in de posts van 2 oktober 2006 en 31 augustus 2007.

Lijkt me leuk als je eens komt kijken als je in de buurt bent...

Menno